12
INSTALLATION AND SERVICE GUIDE
SpeedDome Ultra III Camera Dome
8000-2573-01, REV. B
Connecting to a Standard Base
This procedure explains how to connect the
housing and eyeball assembly to a standard base.
Perform the following steps on the ground.
1. Set dome address (Figure 10).
Recessed at top of housing and eyeball
assembly are three rotary address switches.
Address range is from 001 to 255.
Figure 10. Setting address switches
0
9 0
9 0
9
MSB
LSB
SW3
SW1
SW2
2. Attach coiled safety lanyard to cap on
housing and eyeball assembly (Figure 11).
Three screws secure cap to housing. Each
screw has a protective ridge around it.
a. Locate screw whose protective ridge is
notched.
b. Remove this screw.
c. Use screw to secure lanyard to housing.
Figure 11. Attaching coiled safety lanyard
Only use this
location to
secure lanyard.
