Triplex Digital Video Multiplexer
Appendices
67
Symptom: When switching cameras, the call monitor synchronizes to the new camera very slowly.
Reason:
The monitor's response time (to new video input) is too slow. Usually
it ranges from 0.03 sec. to 1 sec.
Solution:
Use a monitor with a faster response time.
VCR
Symptom: During VCR playback, the update frequency of each camera is not even.
Reason 1:
Multiplexer and VCR record setup are not matched.
Solution:
Check multiplexer and VCR record setup (refer to
Reason 2:
An alarm condition was triggered during recording, and cameras
have different recording priority.
Solution:
This is a normal condition.
Symptom: During VCR playback, the video is frozen.
Reason 1:
Multiplexer REC TIME was set to “SYNC” mode, but the VCR trigger
cable was not connected.
Solution:
Connect the VCR trigger (or SW OUT) signal from the VCR to
multiplexer (refer to
Reason 2:
VCR tape is worn out or the head is dirty.
Solution:
Change the tape or clean the head and try again.
Symptom: During VCR playback, some windows are not displayed.
Reason 1:
If you assign more than one window to display the same camera
channel, only one window can be displayed normally.
Solution:
Do not assign more than one window to the same camera channel.
Reason 2:
That camera channel was not connected during recording.
Solution:
Connect the camera and check that it is recorded properly.
Reason 3:
VCR playback bypasses the multiplexer.
Solution:
Verify that the VCR output is connected to the multiplexer's VCR
Input.
Summary of Contents for Multivision Quest TMV910Q
