©
American DJ Supply
®
- www.americandj.com - Pocket Scan™ Instruction Manual Page 12
©
American DJ Supply
®
- www.americandj.com - Pocket Scan™ Instruction Manual Page 11
CAUTION IMPORTANT!
When installing this projector, make sure
that it is mounted in a manner that prevents the audience from
looking directly into the beam, and the beam from striking the
audience.
Operating Modes:
You can use the Pocket Scan
TM
in three ways:
• Stand alone mode - The unit will react to sound, chasing through
the several built in programs. You can also use the optional
Pocket Scan/RF Remote Control to set blackout, strobe or
slow scan mode.
•
Master/Slave mode - You can daisy chain up to 16 units together to
get a synchronized light show that will react to sound chasing
through several built in programs.
• DMX control mode - This function will allow you to control each indi-
vidual fixtures traits with a standard DMX 512 controller such as the
American DJ Show Designer.
TM
Stand Alone Mode:
The Pocket Scan
TM
has a sophisticated built-in light show that will run
to sound when there is no DMX signal present. P
lug the fixture in and
it will chase through its programs via sound. You can also use the
optional remote to blackout, strobe, or slow scan the units.
Master-Slave Operation:
This function will allow you to link up to 16 units together to run
in a
Master-Slave mode. In Master-Slave operation one unit will act as the
controlling unit and the others will react to the controlling units built-in
programs. Any unit can act as a Master or as a Slave however, units
must be programmed to act as “Masters” or as “Slaves.” There are
two Master-Slave modes, Fast and Slow.
Master-Slave Connections:
1
. Daisy chain your units via the XLR connector on the top of the
unit. Use standard XLR microphone cables to link your units to-
gether. Remember that the Male XLR connector is the input and
the Female XLR connector is the output. The first unit in the chain
(master) will use the female XLR connector only. The last unit in
the chain will use the male XLR connector only.
Setting Units as Masters or Slaves:
This section will detail the procedure for switching units between
Masters and Slaves. Each unit can function as a “Master” or as a
“Slave” To adjust the settings:
1. Be sure the main power switch is set to the “OFF” position.
2. With the power off press and hold down the LCD “100-Key,”
and turn the power on.
3. When the power is applied, the LCD will display the current
DMX address and then display the current Master-Slave
mode. Master-Slave modes will be displayed as followed:
“
S-F
” will equal Master/Send Fast Mode
“
S-S
” will equal Master/Send Slow Mode
“
rEC
” will equal Slave/Recieve Mode
4. To toggle between Master and Slave mode repeat steps one
and two.
Adjusting the Speed of the internal Program:
This section will detail the procedure for changing the Master Unit
operating mode. The master mode may be changed to operate in Fast
or Slow modes.
1. Be sure your unit is in Master mode, see Setting Units as
Masters or as Slaves, above.
2.
Be sure the main power switch is set to the “OFF” position.
3. With the power off press and hold down the LCD “10-Key,”
and turn the power on.
4. When the power is applied, the LCD will display the current
DMX address and then display the current Master-Slave
mode. Master-Slave modes will be displayed as followed:
Pocket Scan™ Operating Instructions
Pocket Scan™ Operating Instructions
100
1
10
Pocket Scan™ LCD
