![background image](http://html1.mh-extra.com/html/american-dj/inno-spot-led-wifly/inno-spot-led-wifly_user-instructions_2923006004.webp)
ADJ Products, LLC - www.adj.com - Inno Spot LED WiFly Instruction Manual Page 6
ADJ Products, LLC - www.adj.com - Inno Spot LED WiFly Instruction Manual Page 7
Power Supply:
Before plugging your unit in, be sure the source volt-
age in your area matches the required voltage for your ADJ Inno Spot
LED WiFly. The ADJ Inno Spot LED WiFly is available in a switchable
120v and 220v version. Because line voltage may vary from venue to
venue, you should be sure your unit voltage matches the wall outlet
voltage before attempting to operate you fixture. Also be sure to only
use the included I.E.C. power cable supplied with the unit, this cable
matches the voltage and current requirements of the unit.
DMX-512:
DMX is short for Digital Multiplex. This is a universal pro-
tocol used by most lighting and controller manufactures as a form of
communication between intelligent fixtures and controllers. A DMX
controller sends DMX data instructions from the controller to the fix-
ture. DMX data is sent as serial data that travels from fixture to fixture
via the DATA “IN” and DATA “OUT” XLR terminals located on all DMX
fixtures (most controllers only have a DATA “OUT” terminal).
DMX Linking:
DMX is a language allowing all makes and models
of different manufactures to be linked together and operate from a
single controller, as long as all fixtures and the controller are DMX
compliant. To ensure proper DMX data transmission, when using
several DMX fixtures try to use the shortest cable path possible. The
order in which fixtures are connected in a DMX line does not influence
the DMX addressing. For example; a fixture assigned a DMX address
of 1 may be placed anywhere in a DMX line, at the beginning, at the
end, or anywhere in the middle. Therefore, the first fixture controlled
by the controller could be the last fixture in the chain. When a fixture
is assigned a DMX address of 1, the DMX controller knows to send
DATA assigned to address 1 to that unit, no matter where it is located
in the DMX chain.
Data Cable (DMX Cable) Requirements (For DMX
and Master/Slave Operation):
The Inno Spot LED
WiFly can be controlled via DMX-512 protocol.
The Inno Spot LED WiFly is a ten channel DMX
unit. The DMX address is set electronically using
the controls on the front panel of the unit. Your
unit and your DMX controller require a approved
DMX-512 110 Ohm Data cable for data input and
Inno Spot LED WiFly Set Up
Figure 1
Screw one clamp via a M12 screw and nut onto the Omega
holder. Insert the allen bolts into the respective holes on the
bottom of the Inno Spot LED WiFly. Attach the safety-cable
through the eyehole hook on the bottom of the base and over
the trussing system or a safe fixation spot. Insert the end in the
carabine and tighten the safety screw.
NOTICE:
The suitable enviromental temperature for this light-
ing fixture is between -25˚ C to 45˚ C. Do not place this lighting
fixture in an enviroment where the temperatures are under or
above the temperatures stated above. This will allow the fixture
to run at its best and help prolong the fixture life.
Inno Spot LED WiFly
Installation