ADJ Products, LLC - www.adj.com - Inno Spot LED WiFly Instruction Manual Page 18
ADJ Products, LLC - www.adj.com - Inno Spot LED WiFly Instruction Manual Page 19
This feature will let you link units to run in a master-slave mode with-
out the use of XLR cables.
1. Follow the instructions on page 11 to set the Wireless address.
The addresses on each fixture must be the same.
2. After you have set the WiFly address, select your master unit and
set your desired operating mode.
3. Put the antenna in either a up position or down position then turn
the WiFly on. See page 11 to activate WiFly.
Note: All antennas must be in the same position, they must either be
all up or all down, but never at an angle.
4. For the Slave units, put the unit in Slave mode. See page 12.
Then activate WiFly.
5. If everything is set up correctly, the Master units signal strength
will be displayed in the WiFly signal status window located on the
rear of the unit.
NOTE: If they do not sync up master-slave, switch the Master fix-
tures power off then on again.
Inno Spot LED WiFly
Operation
2. To control your fixture in DMX mode, follow the set-up procedures
on pages 5-7 as well as the set-up specifications that are includ-
ed with your DMX controller.
3. Use the controller’s faders to control the various DMX fixture traits.
4. This will allow you to create your own programs.
5. Follow the instruction on page 11 to set the DMX address.
6. For longer cable runs (more than a 100 feet) use a terminator on
the last fixture.
7. For help operating in DMX mode consult the manual included
with your DMX controller.
Sound Active Mode:
This mode allows either single unit or several
units linked together, to run to the beat of the music.
1. Press the MENU button until
“
SOUN
” is displayed, and press
ENTER. Tap the UP or DOWN buttons so that “
ON
” is dis-
played and press ENTER.
Show Mode:
This mode allows either a single unit or several units
linked together, to run one of four shows that you choose. See pages
11-12 for more information.
1. Press the MENU button until
“
SHND
” is displayed, and press
ENTER.
2.
Press the UP or DOWN buttons until you find your desired show,
and press ENTER.
Inno Spot LED WiFly UC3 Control
The optional UC3 Controller (not included) may be used to con-
trol different functions including blackout.
Stand By Blackout the unit
Function 1. Sync. Strobe
2. Async strobe
3. Sound Strobe
Show
1-4
1. Select Color
2. Select Gobo
Mode
Sound (LED OFF)
Show (LED
Slow Blinking)
LED ON
Inno Spot LED WiFly
WiFly Master-Slave Set Up
