![background image](http://html1.mh-extra.com/html/american-dj/dmx-operator-ii/dmx-operator-ii_user-manual_2922608013.webp)
2.2 Programming Scenes
2.2 Programming Scenes
2. Operation Guide
2. Operation Guide
6. Tap the Bank Up/Down button to select the bank
you want to store your scene into. There are total
30 banks you can select, you may store up to 8
scenes into each bank.
SCENE BUTTONS 1-8
7. Tap the Scene button to store your scene, all
LEDs and the Segment Display will flash three
times briefly indicating this operation, then the
LCD will show the bank and the scene.
8. Repeat steps 3-7until all desired scenes
have been programmed into memory.
Tap the Scanner button again to turn off
its fader control.
To set another scanner(scanner), you may tap
the corresponding Scanner button to turn on
its fader control, then you may begin your
programming again.
9. If you don't intend to continue your programming,
press and hold down the Program button for three
seconds to exit Program mode, the LED goes out
indicating this selection.
EXAMPLE:
Program 8 scenes with channel 1-8 at full in sequence into
bank 2 and assign these scenes to scanner 2.
1. Program enable.
2. Tap the Scanner 2 button to turn on its fader control.
3. Tap the Page Select button to select Page A.
4. Push Fader 1 to the top position.
5. Tap the MIDI/Rec button.
6. Select bank 2 using Bank Up/Down button.
7. Tap the Scene 1 button to store the first scene.
8. Repeat steps 4-7 until all 8 scenes have been programmed into bank 2.
9. Tap the Scanner 2 button again to turn off its fader control.
10. Press the Program button for 3 seconds to exit Programming mode.
9
10
BANK
Scanner buttons 1-12
Program