American DJ
®
- www.americandj.com - Accu UFO PRO Instruction Manual Page 26
American DJ
®
- www.americandj.com - Accu UFO PRO Instruction Manual Page 25
FEED
- With this function you can switch the Pan/Tilt error
correction on and off. This will automatically correct the
Pan/Tilt if it is somehow moved out of place.
1. Access the main menu.
2. Tap the UP button until “
SPEC
” is displayed, press ENTER.
3. Tap the UP button until “
FEED
” is displayed, press ENTER.
4. Press the UP or DOWN buttons to select either “
ON
” to acti-
vate this function, or “
OFF
” to deactivate this function.
5. Press ENTER to confirm.
6. Press MODE/ESC to return to the main menu.
HIBE
-
With this function you can make the unit auto-
matically shut down the lamp and stepping motors. The
default setting for this is 15 mins. After 15 mins if the unit
is not receiving a DMX signal, the unit will automatically
shut down the lamp and motors. This feature lengthens
the life of the lamp and motors. The shut down time can be
adjusted between OFF (no shut down) or 1 - 99 minutes.
Once the lamp and motors are shut down, it will reset itself
when it receives a DMX signal. When the function is set to
OFF, the lamp and motors will not shut down until power is
cut.
1. Access the main menu by pressing MODE/ESC button.
2. Tap the UP button until “
HIBE
” is displayed, press ENTER.
3. Press the UP or DOWN buttons to adjust the shut down time.
4. Press ENTER to confirm your selection.
5. Press MODE/ESC to return to the main menu.
Accu UFO PRO
System Menu
“7”, Channel 2 value to “8”, and Channel 3 to “164”. (256 + 164
= 420)
SPEE
- With this function you can select the movement
mode
1. Access the main menu.
2. Tap the UP button until “
SPEC
” is displayed, press ENTER.
3. Tap the UP button until “
SPEE
” is displayed, press ENTER.
4. Press the UP or DOWN buttons to select either “
SP-1
” or
“
SP-2
”.
5. Press ENTER to select your desired mode.
DFSE
- With this function you can restore the factory
settings of the device. All settings will be set back to the
default values. Any edited scenes will be lost. When restor-
ing the factory settings the unit must be set to the address
that the unit was in when you started editing.
1. Access the main menu.
2. Tap the UP button until “
SPEC
” is displayed, press ENTER.
3. Tap the UP button until “
DFSE
” is displayed, press ENTER.
4. The display will show “
ON/OFF
”.
5. Press the UP button to display “
ON
” to activate this function,
or “
OFF
” to deactivate this function.
6. Press ENTER to confirm.
7. Press MODE/ESC to return to the main menu.
When you exit this function, the unit will begin to reload
data.
Accu UFO PRO
System Menu
