- 36 -
A.
Setting sequence
1
Device selection: from 1 to 4.
2.
Select command]
3.
Set byte of command:max.15.byte of commands not used for each
device must be set at 0.
4.
Input protocol of selected command
5.
Repeat process from 1 to 4 until you complete to input protocol
for all commands you need.
~
Use REC button to copy and PLAYBACK button to paste, in case
there are many protocols similar to each other.
B.
How to input protocol
1.
User must select commands needed for PTZ cameras(from 1st to
4th DEV),and input len and protocol(HEX-code). For commands
not used for your PTZ cammer, len value must be set at
0.Commands whose len are 0 are not shown when you practically
control PTZ camera later.
2.
Using buttons, move to item you want to select or set, and
use LEFT and RIGHT buttons to set values.
3.
You can input protocol using numerical buttons on the front of
DVR unit or remote controller. following table shows buttons
corresponding to each HEX-code for protocol.
HEX-CODE
1 2 3 4 5 6 7 8 9 A B C D E F 0
BUTTON ON
THE FRONT
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
BUTTON ON
REMOTE
CONTROLLER
1 2 3 4 5 6 7 8 9 0,0 0,1 0,2 0,3 0,4 0,5 0,6