Cleaning, maintenance and repairs
Cenius 4002-2T BAG0100.2 04.13
79
12.4
Installing and removing the tines
CAUTION
The tines and coulter of the Cenius can be replaced when on the
field. For this purpose, slightly raise the machine in order to minimise
the risk of injuries by the machine lowering unintentionally.
12.5
Changing the coulters
CAUTION
Take special care when changing
coulters.
Do not turn the screws on the
square shaft.
Risk of injury from sharp edges.
Fig. 51
12.5.1 Changing the Vario-Clip coulters
To remove the Vario-Clip coulter (Fig. 52/1),
knock the spiral pin (Fig. 52/2) out by knocking it
downwards using a drift and remove the coulter
towards the front.
To install the Vario-Clip coulter, slide it in and
secure with the spiral pin.
CAUTION
Coulters are made of hardened ma-
terial. If you use a hammer for the
mounting/removal procedures, the
ends may break off and cause con-
siderable injury.
You must wear protective goggles
and gloves.
Fig. 52
12.6
Replace the tension springs of the overload safety device (workshop
work)
CAUTION
Cenius Super
:
The overload safety on the tines consists of two tension springs in
each case. They are under high pretension. You must use the device
to mount and remove the tension springs in all cases.
Otherwise, there is a risk of injury.
