General safety instructions
28
Cenius 4002-2T BAG0100.2 04.13
2.16.3 Electrical system
When working on the electrical system, always disconnect the
battery (negative terminal).
Only use the prescribed fuses. If fuses are used that are too
highly rated, the electrical system will be destroyed – danger of
fire!
Ensure that the battery is connected correctly - firstly connect the
positive terminal and then connect the negative terminal. When
disconnecting the battery, disconnect the negative terminal first,
followed by the positive terminal.
Always place the appropriate cover over the positive battery
terminal. There is a danger of explosion in the event of an acci-
dental earth contact!
Danger of explosion! Avoid the production of sparks and naked
flames in the vicinity of the battery!
The machine can be equipped with electronic components, the
function of which may be influenced by electromagnetic interfer-
ence from other units. Such interference can pose risks to peo-
ple, if the following safety information is not followed.
In the case of retrofitting of electrical units and/or compo-
nents on the machine, with a connection to the on-board
power supply, the user must check whether the installation
might cause faults on the vehicle electronics or other com-
ponents.
Ensure that the retrofitted electrical and electronic compo-
nents comply with the EMC Directive 2004/108/EC in the
latest version and bear the CE mark.
2.16.4 Coupled machines
Observe the permitted combination options of the attachment
equipment on the tractor and the machine drawbar.
Only couple permitted combinations of vehicles (tractor and at-
tached machine).
On single axle machines, observe the maximum permitted draw-
bar load of the tractor on the attachment equipment.
Ensure that the tractor has sufficient steering and braking power.
Machines attached or coupled to a tractor influence the driving
behaviour and steering and braking power of the tractor, and in
particular single axle machines with drawbar loads on the tractor.
Only one specialist workshop can adjust the height of the draw-
bar if it is a straight drawbar with drawbar load.
