Amano MTX-30B/A966, Installation & Operation Manual

Page: 18 / 48

Installation & Operation Guide Page 17 of 48
3. Upon verification, the screen will display your Name, User ID, and the confirmation " Verified. " with the voice prompt
" Thank you " followed by the momentary display of your hours worked for the active pay period.
View Hours at the Clock F-1
1. Press the F1 key and the terminal will ask for Badge No. or Finger Print
2. Enter Badge No or place finger on the fingerprint reader and hours will show on display.
Note: If View Hours is enable: Hours displayed are from the last download to the terminal.
Department Transfer at the Terminal F-2
1. Press the F2 key and select department by using the up and down keys (
▲▼)
2. Press ok after selecting the department
3. Enter Badge No or place finger on the fingerprint reader. Employee name and hours worked will show after punch.
Note : Department Transfer needs to be configured and downloaded to the clock from Time Guardian.
View Previous Punch at the Terminal F-3
1. Press the F3 key View Previous Punch and the terminal will ask for Badge No. or Finger Print
2. Select Date and press Ok to display previous punches.
Note: Previous punches are reset (cleared) every time the clock is polled.
Labor Transfer at the Terminal F-4 (optional module in Time Guardian )
1. Press the F4 key and select number 1 through 4 by using the up and down keys (
▲▼)
2. Press ok after selecting one of the options
3. Enter Badge No or place finger on the fingerprint reader. Employee name and hours worked will show after punch.
Note: Labor Transfer needs to be configured and downloaded to the clock from Time Guardian. This is an optional module
sold separately.
Enrolling Users at the MTX-30
– Finger Print Terminal
After installing the MTX-30 Fingerprint terminal and powering on, you may begin enrolling users. If this is the first
enrollment in a new or empty clock system, everyone will be able to enroll. However, if there are any users with privileges
already setup in the system, you will have to be enrolled by a user with privileges. The MTX-30 fingerprint reader provides
the following two methods for enrollment; fingerprint and password.
Use care when enrolling users at the terminal as the
ESC button can alter the entry fuctions during some operations.
Enrolling Users at the MTX-30
– Proximity, MAG-Stripe, BarCode Print Terminal
After installing the MTX-30 card terminal and powering on, you may begin enrolling users. If this is the first enrollment in
a new or empty clock system, everyone will be able to enroll. However, if there are any users with privileges already setup
in the system, you will have to be enrolled by a user with privileges. The MTX-30 Card reader provides the following two
methods for enrollment; password and card.
Use care when enrolling users at the terminal as the
ESC button can alter the entry fuctions during some operations.
Enrolling Users at at the MTX-30
– Fingerprint terminal
After installing the MTX-30 Fingerprint terminal and powering on, you may begin enrolling users. If this is the first
enrollment in a new or empty clock system, everyone will be able to enroll. However, if there are any users with privileges
already setup in the clock system, you will have to be enrolled by a user with privileges. The MTX-30 fingerprint reader
provides the following four methods for enrollment; fingerprint, password, fingerprint and password and fingerprint or
password.
Use care when enrolling users at the terminal as the
ESC button can alter the entry fuctions during some operations.