Amano A-VAC 12 07212A, Operator'S Manual, Page: 15 / 40

15
Using the Machine - Wet
To start working, proceed as follows:
1. Perform all the checks indicated in the section “ PREPARING THE MACHINE ”.
2. Free the vacuum head from the collection tank by releasing the hooks (1) on the side of the tank. Rotate the
levers as shown by the arrow in the picture on the right.
3. Use the handle (2) on the vacuum head unit to remove it from the collection tank.
4. Rest the head carefully on the ground.
5. Make sure the float unit is inserted in the collection tank. If this is not the case, position it correctly.
WARNING: There must be no solid waste residue inside the collection tank.
6. Use the handle (2) on the vacuum head unit to position it above the collection tank. Make sure the machine’s
power supply cable is in the rear part of the tank.
7. Fix the vacuum head to the collection tank by coupling the hooks (1) on the side of the tank. Rotate the levers
as shown by the arrow in the picture on the right.
8. Insert the plug (3) of the power supply cable (4) in the electrical outlet and/or power socket (5).
9. Switch on the machine by bringing the main switch (6) to the work
position “I”.
10. Carry out the cleaning work.
NOTICE: If the vacuuming intensity diminishes while you are
working, see the section “ IMPROVING THE VACUUMING
PERFORMANCE ”.
The machine is fitted with a mechanical device (float) under the vacuum
lid. When the collection tank is full, this device shuts off the air to the
vacuum motor to protect it; you will recognise this condition by the deeper
noise made by the motor. When you hear this sound, you must empty the
collection tank (see the section “ EMPTYING THE COLLECTION TANK ”)