April 1998
97
RS5290000 Rev. 0
Kit Instructions
Introduction
Important
• Mechanical experience is required to install trim kit.
• Depending on installer’s knowledge and skill,
installation can take from one to three hours.
• Transfer food to an alternate cooling source. Check
refrigerator warranty certificate for specific
coverage. Warranty does not cover food loss.
• Ensure trim pieces adhere properly by confirming
surfaces are clean, dry and free of adhesive
residue.
• If unable to solve a problem during installation,
contact source from whom kit was purchased.
Decorator Panel Dimensions
Listed below are required height x width dimensions for
decorator panels. Panels are not supplied with this kit
and can be purchased locally.
Caution
To avoid personal injury or property damage,
refrigerator panels should not weigh more than 30
pounds (14 kilograms) and freezer panels should not
weigh more than 15 pounds (7 kilograms).
Without Dispenser
Refrigerator Door
63 3/32" x 19 3/8"
(1603 mm x 492 mm)
Freezer Door
63 3/32" x 13 3/4"
(1603 mm x 349 mm)
With Dispenser
Refrigerator Door
63 3/32" x 19 3/8"
(1603 mm x 492 mm)
Upper Freezer Door
18 3/8" x 13 3/4"
(467 mm x 349 mm)
Lower Freezer Door
31 13/16" x 13 3/4"
(808 mm x 349 mm)
Procedure
Caution
To avoid personal injury or property damage, two
people should remove and rehang each door.
Caution
To avoid personal injury, protect hands and arms. Trim
pieces may have sharp edges.
Important
Save all screws and reuse in original location.
1. Remove top handle end caps by removing screws.
2. Dispenser Models
Remove crushed/cubed ice switch cover on
dispenser by pulling forward. Remove screws from
bottom of dispenser cover. Release bottom clips on
dispenser cover by placing taped edge of putty knife
underneath cover and pulling out. Release top clips
by holding bottom of dispenser cover out and slide
upward.
