April 1998
95
RS5290000 Rev. 0
Kit Instructions
3.
Remove door handle inserts by placing screwdriver
at top of door handles in area between handle and
insert and pulling forward.
4. Pull edge of inserts forward along length of handles.
CAUTION
To avoid property damage, place masking tape on
back of panel at each corner. Tape prevents panel
from damaging doors.
7.
Cover back edges of cardboard with masking tape.
Place several evenly spaced strips of masking
tape on rear of cardboard.
8.
Non Dispenser Models
Open doors. Place bottom of panels in bottom trim
then place top of panels under top trim. Slide panels
into place until panels are seated firmly under side
trim.
Dispenser Models
Open doors. Place bottom of refrigerator panel in
bottom trim then place top of panel under top trim.
Place bottom of lower freezer door panel in bottom
trim then place top of panel under dispenser cavity.
Place bottom of upper freezer door panel in top of
dispenser cavity then place top of panel under top
trim. Slide panels into place until panels are seated
firmly under side trim.
9.
Replace door handles by placing door handles on
doors. Insert and tighten screws. Replace handle
inserts by snapping in place.
10. Dispenser Models
Replace dispenser cover by snapping in place. Insert
and tighten screws. Replace switch by snapping in
place.
11. Remove thin section on top handle end caps to allow
room for panels. Discard section. Replace top
handle end caps by placing end caps on handles.
Insert and tighten screws.
12. Peel protective wrap off front of panels.
Thin Section
5.
Remove door handles by removing screws.
Important
Do not remove cardboard from panels. Panels will not fit
properly if cardboard is removed.
6.
Dispenser Models
Locate dispenser trim in top crisper drawer. Install
dispenser trim on freezer panels by sliding trim on
bottom edge of upper freezer door panel and top
edge of lower freezer door panel.
CAUTION
To avoid personal injury or property damage, hold
handles when removing.
!
!
