RS5290000 Rev. 0
100
April 1998
Kit Instructions
Thin Section
21. Remove thin section on top handle end caps to
allow room for panels. Discard section. Replace
top handle end caps by placing end caps on
handles. Insert and tighten screws.
22. Dispenser Models
Replace dispenser cover by snapping in place.
Insert and tighten screws. Replace switch by
snapping in place.
23. Install new top door trim by placing trim on top of
doors. Insert screws but do not completely tighten.
When installing HTK200E and HTK220E, install new
color coordinated screws taped to trim.
24. Dispenser Models
Install new dispenser trim on freezer panels by
sliding trim on bottom edge of upper freezer door
panel and top edge of lower freezer door panel.
25. Slide decorator door panels into place until panels
are secure under door handle inserts.
Important
Permanent, double-sided tape is used to attach some
trim pieces to refrigerator. Before removing paper
backing, check placement of trim pieces on refrigerator.
Trim pieces may be damaged if adjustment or removal is
attempted after installation.
26. Install side door trim by peeling off 1 1/2 inches
(38 millimeters) of backing. Place trim against
bottom corner of refrigerator cabinet over edge of
bottom trim. After checking placement, peel off
backing and press into place. Place side door trim
under edge of top trim. Tighten top trim screws.
27. Push water tube into plastic union nut and tighten
union nut by hand. Gently pull on tube to confirm
nut is tight. Tighten water tube clamp screw.
Caution
To avoid property damage, confirm water tube union
nut is secure before replacing toe grille.
28. Install new toe grille (if supplied) by inserting clips in
holes and snapping in.
Side Trim
Bottom Trim
