April 1998
69
RS5290000 Rev. 0
Fill Cup
Remove module and support assembly. Remove
ejector blades and shut-off arm. Pull fill cup from
mold.
Ejector Blades or Stripper
Remove module and support assembly. When rein-
stalling ejector blades, realign "D" coupling with mod-
ule cam.
Accessing Control box
To remove motor and contact assembly from control box,
take out three screws (arrows) and pull free after discon-
necting shut-off arm.
To avoid damange to main assembly, do not rotate
blades or drive gear.
There are several switches which will jam if manually
turned counterclockwise and gears will be destroyed if
turned clockwise. To advance the ice maker into the
cycle, use a jumper to bridge
H to R and unless the
motor is defective, it will run. (The shut-off arm must
be in the on position.)
NOTE: There are several slotted shafts on the motor
assembly board. Do not under any circumstances in-
sert a screwdriver and attempt to turn these shafts.
The slots are to permit assembly only.
NOTE: There are not repairable or replaceable com-
ponents in the module. Unless you are replacing the
module, there should be no need to remove it when
diagnosing or repairing the ice maker.
Water valve
energized
7.5 seconds
140cc fill
about 11:00
o'clock
Ejector blade stop position
(about 1:30 o'clock
Start position:
thermostat closes,
motor on,
heater on
Ejector stall on ice,
Motor on (30 seconds
to 5 minutes) about
4:00 o'clock
6:00 o'clock
position
Thermostat
opens in this
range of
rotation then
heater is off
Ice Maker
CAUTION
!
Remove appropriate
fill cup slot .
Forcefully pull cup up
and out of slot .
Mold and Heater Screw Access Ports
