22
PROPER INSTALLATION
CONFIGURATION SETTINGS FOR R410A
G SERIES MODEL BOARDS
7 BUTTON TOUCH PAD WITH DISPLAY
The control can be configured to operate a wide range of
options. The options listed below with the * are the factory
default settings. If these are acceptable, then the unit does
not require any additional configuration and is fully oper-
able. To configure the unit, first select the configuration
feature code setting and then an option code to change
from the factory default setting.
To
enter configuration feature mode
:
1.
Press
and
hold
the up and down
arrow keys at the
same time and
press
the
OFF
key
twice within
a two (2) second time frame
. The display will indi-
cate - -., and then release the
key and press the
key one time. The display will then alternate be-
tween
C1
and
0
.
To select a different configuration
feature code
,
press the
HEAT
key until the desired configu-
ration comes up. To scroll to a previously viewed con-
figuration codes press the
COOL
key.
Once you have scrolled to the correct feature, then to
select the
option code
for your desired configuration,
press either the up or down key
to scroll through
the options of the selected feature code.
To
exit configuration mode
:
1.
Press
the
OFF
key. Configuration feature
mode will also exit
if no keys are pressed
for a pe-
riod of
two (2) minutes
.
Refer to the Configuration Chart.
Wireless Communications
PTAC models
PT**G***
have the option to use a wireless
thermostat and door sensor. These features will only work
on the models listed above. The thermostat and /or door
sensor will require an antenna for communication with the
digital control board.
ANTENNA INSTALLATION FOR DT01* KIT
A DT01* antenna must be installed on the digital PTAC to
allow operation of either the DS01* remote RF thermostat
or a DD01* combination PIR motion sensor and door switch.
PREPARATION
1. Disconnect power to the unit by unplugging the power
cord at the wall outlet or subbase, or disconnect power
at the fuse box or circuit breaker.
2. If the cabinet front is screwed to the chassis, remove
the 1/4” screw (or screws). See following figure.
Front Mounting Screw
accessed
through louvers.
3. Remove cabinet front from chassis by tilting the bot-
tom of the front forward, lifting slightly up and for-
ward.
4. Mount the antenna as high up on the control panel as
possible and as far to the right as possible in a location
that will not interfere with the reinstallation of the PTAC
polymer room front. Mark holes for screw location. Re-
move antenna housing and drill two 1/8” holes where
marked. Some units may have the holes already pre-
drilled in the correct location.