ALZRC DEVIL X360, Instruction Manual, Page: 21 / 38

组装说明 ASSEMBLY SECTION
尾旋翼主轴
Tail Rotor Shaft
Chapter 33
尾齿箱安装
Installation of Tail Case
Chapter 32
DX360-J
20
第 29 步组装完成
Assembled in Chapter 29
第 31 步组装完成
Assembled in Chapter 31
垫片
Washer
Φ2xΦ4.5x0.5mm
圆头内六角自攻螺丝
Socket Head Tapping Screw
M2x6mm
螺丝锁入塑胶零件请勿过度拧紧。
Do not over-tighten the screws
into the plastic parts.
将尾齿传动皮带穿过尾齿箱，如图！
Pass the belt through the tail case, as the figure
shown!
第 32 步组装完成
Assembled in Chapter 32
尾旋翼主轴
Tail Rotor Shaft
Φ4x47
. 6mm
垫片
Washer
Φ4xΦ6x0.1mm
第 30 步组装完成
Assembled in Chapter 30
尾齿箱盖-左
Tail Case Cap-Left
半圆头内六角螺丝
Socket Button Head Collar Screw
M2x4mm
尾旋翼主轴
Tail Rotor Shaft
Φ4x47
. 6mm
已经完成组装
AIready Assembled
出厂零件包装如果是已组装品，请务必确认各部件是否
锁紧上胶。
For original manufactory package, If the product is
already assembled by factory, please check again if
parts are firmly secured and applied with some glue.
插销
Bolt
Φ1
. 5x10 . 5mm
尾皮带轮
Tail Pulley
尾皮带轮零件
Tail Pulley Parts
止泄螺丝
Set Screw
M2x4mm
检测尾旋翼主轴与尾齿箱间隙，可以通过加垫片的
方式减少间隙。
Check the gap between the tail shaft and the tail
case, the gap can be reduced by adding washers.
注意：请认真检查，以确保齿轮能顺滑转动，如果
不顺滑，可以减少一片垫片，直到齿轮确保顺滑转
动。
Note: Check the tail pulley carefully to make sure
you can rotate it smoothly. If you feel too much
friction, you have to remove a washer until the
it can rotate smoothly.
螺丝锁入塑胶零件请勿过度拧紧。
Do not over-tighten the screws
into the plastic parts.
DX360-J