ALZRC DEVIL X360, Instruction Manual, Page: 15 / 38

组装说明 ASSEMBLY SECTION
齿轮总成
Gear Assembly
Chapter 21
DX360-F
14
前尾驱动皮带轮组
Front Tail Pulley Assembly
Chapter 20
DX360-F
第 18 步组装完成
Assembled in Chapter 18
第 19 步组装完成
Assembled in Chapter 19
圆头内六角螺丝
Socket Head Screw
M2x5mm
24
3
24
3
确保上齿轮固定座锁入单向轴承套最
底处。
Make sure the front tail pulley hub
is locked into the bottom of the
one-way bearing sleeve.
注意皮带轮的定位销。
Please pay attention to the
positioning pin of the pulley.
第 20 步组装完成
Assembled in Chapter 20
第 17 步组装完成
Assembled in Chapter 17
卡簧
Circlip
垫片
Washer
Φ10xΦ13
. 5x0.1mm
装配卡簧后，检测斜主齿轮与皮带轮间隙，可以通过加垫
片的方式减少间隙。
Check the gap between the helical main gear and the
pulley after install the circlip. The gap can be reduced
by adding washers.
注意：请认真检查，以确保齿轮能顺滑转动，如果不顺滑，
可以减少一片垫片，直到齿轮确保顺滑转动。
Note: Check the main gear carefully to make sure
you
can rotate the main gear smoothly. If you feel too
much friction, you have to remove a washer until the
gear can rotate smoothly.