ALZRC DEVIL 380 FAST, Instruction Manual, Page: 16 / 38

15
D380F - E - 2
马达传动皮带
Performance Motor Belt
Chapter 21
第 19 步组装完成
Assembled in Chapter 19
马达传动皮带
Performance Motor Belt
304-2GT-09
马达传动皮带安装到齿轮以后，马达固定座
需往外拉紧，用手将电机旋转几次，再拧紧
马达固定座的螺丝。
Pull motor mount and rotate the motor
after install the driven belt. And then
tighten the screw to adjust the proper
tension on belt.
注意：马达传动皮带必须非常紧。
Note: The driven belt must be really
tightened.
0 . 75mm
0 . 75mm
用手转动马达，检查马达传动皮带的垂直情况，皮带与皮带轮必须正确对齐 ( 视下图 ) ，上下间距 0.75mm 。
如果转动后，皮带并非对齐，请检查马达皮带轮，皮带向上偏移，马达皮带轮向下调，皮带向下偏移，马达皮带轮向上调。
Check for vertical alignment of the motor pulley. To do this, simply turn the motor several times by hand and check to you see if the belt is
aligned properly with the big pulley (one way bearing pulley).
If the belt is riding too high, simply loosen up the motor pulley and drop it just a little bit, if it is riding too low, loosen up the
motor pulley and raise it a bit.
组装说明 ASSEMBLY SECTION