Alvarion BreezeACCESS II CX, System Manual

Page: 56 / 78

Chapter 3 - Commissioning
Basic P rameters in 2.4 GHz Units (SW Version 4.5) a
NOTE
Units running SW version 4.5 that use FCC hopping standard can be configured to
operate in HDM mode. This enables better performance in high interference
environments by providing the ability to configure the units to use only interference-free
channels, including hopping synchronization support.
WARNING
For compliance with IC&FCC regulations, the AU and SU units in HDM mode must be
configured to ensure that the output power does not exceed 19 dBm. In legacy units that
were upgraded from firmware version 4.3 or lower, it is mandatory to attach the new
IC&FCC HDM ID label to the unit. The HDM ID label is only available from Alvarion
when ordering the Firmware 4.5 Upgrade Kit.
The maximum output power levels for compliance with the applicable
IC&FCC regulation are listed below:
T ompliance able 3-2: Maximum Output Power for IC&FCC C
Operation Mode Max Output
Power
IC&FCC ID Label
FH (Non HDM) 26 dBm FH Mode
HDM 19 dBm FH Mode & *HDM Mode
* IC 2514A-IF24SYNC FCC ID LKT-IF-24-SYNC
Table 3-3: Basic Parameters in 2.4 GHz Units
Parameter Default Value Comment
IP Address 10.0.0.1
Subnet Mask 255.0.0.0
Default Gateway Address 0.0.0.0
DHCP Options Disable
Access to D
AU:From Ethernet Only
HCP SU: From Wlan Only
Cell Extender System Manual
3-6