Alvarion BreezeACCESS II CX, System Manual

Page: 48 / 78

Chapter 2 - Installation
Connecting the Cables
the ground cable to a suitable ground
connection.
e able(s) between the radio unit and the
appropriate connector (SU-IF or AU-IF) located on the bottom panel
of the unit.
2. The IF cable connectors should be sealed properly to protect against
rain and moisture.
1. Connect one end of the ground cable to the ground stud.
2. Connect the other end of
1. Connect th IF coaxial c
CAUTION
Do not connect or disconnect the IF cables while the Interface unit is powered.
1. Remove the two screws holding the applicable service box (marked
SU) to the unit and remove the s rvice box.
2. Unscrew the to tal
disk inside, remove it.
Route the uncrimped end of the indoor-to-outdoor Cat. 5 Ethernet
ugh both the top nut and the service
e
p nut from the service box. If there is a sealing me
3.
cable (8-wire, 24 AWG) thro
box.
NOTE
The ed. 8-wire cable should be shield
To connec t the ground cable:
To connect the IF cables (900 MHz and 2.4 G Hz equipment):
To connect the indoor-to-outdoor Ethernet cable (for connecting to
BreezeACCESS VL units):
Cell Extender System Manual
2-18