TAS12-EDM & TAS12P-EDM Installation Instructions
PUD4005R1-0
For Assistance: [email protected] +1 (909) 591-8431
Page 7
•
For fixed turnstile installations, proceed to the Installation Instructions beginning on page 8.
• For portable turnstile installations, proceed to Appendix A - Portable Base Turnstile on page 24.
Depending on whether you are installing fixed or portable turnstiles, certain sections of this manual may not be
applicable to your installation.
Fixed Installation
1. Anchor the turnstile to the concrete slab.
2. Connect primary power.
3. Mount the TAS12 unit to the turnstile lid.
4. Attach the TAS12 wireless antenna (if applicable).
5. Connect cables that interconnect the turnstile and
TAS12 unit.
6. Connect the Ethernet cable for network
communication (if applicable).
7. Inspect installation.
8. Perform a post-installation functions check.
9.
Hand off instruction manuals to the project or site
manager.
Portable Installation
1. Install the guide rail to the portable base plate.
2. Mount the TAS12 unit to the turnstile lid.
3. Attach the TAS12 wireless antenna (if applicable).
4. Connect cables that interconnect the turnstile and
TAS12 unit.
5. Connect the Ethernet cable for network
communication (if applicable).
6. Inspect installation.
7. Wire Neutrik connector to AC power cord (AC power
cord not supplied by Alvarado).
8. Connect to an AC power source.
9. Perform a post-installation functions check.
10.
Hand off instruction manuals to the project or site
manager.
Installation Steps
Before you Begin
