ADJUSTMENT
6.3
ATTENTION!
Before the first programming of the remotes, clean the drive memory from
the previously recorded remotes. lf the remote control is absent, the number of the absent
remote control must be deleted from the memory to prevent the unauthorized entry. lf the
number of the absent remote control is unknown, delete all numbers of the remotes and re
record all remote controls.
SETTINGS OF OPERATION VALUES
The
tab/e 15
shows an example to enter the settings menu and to set the operation values.
2
3
4
5
6
7
8
Press and hold the button I PR./ ( i for about 5 secs to enter the
programming mode
After the appearance of'Pl' inscription press the button
IOP./ Ai
or
IO../vi
and select the required menu 'PN!!'
After the appearance of the required menu inscription press the
button
[ST./
►I
With the button
IOP./ Ai
or
IO../vi
select the required setting 'FN2'
After the appearance of the required setting inscription press the
button
[ST./
►I
The value of settin
D
will be
i
on a display. The value will be with a dot. With the
button
IOP./ Ai
or
0../v
select the required value of setting
After the appearance of the required value of setting press the button
[ST./
►
�
The value will be with a dot, that means the change the setting
To exit the programming mode press the button IPR./(ithree times orwait
for 15 seconds (until automatic exit the setup menu)
Tobte 15
�
The
table 16
describes the settings, values of setting and default values for the drive supply.
Pl
F4
P3
Fl
.
.
.
The adjustment of end positions.
The function is
designed to monitor and ad just the end positions
once every 100 cycles of raising and lowering the
VALUES
gate
(fig.
16)
no-OFF/on-ON
Automatie mode.
The control is performed by
means of short presses on the control button
Tobte 16
. .
no.
on.
LEVIGATO DRIVES (LG SERIES) LEVIGATO ANTRIEBE (SERIE LG) COMMANDES LEVIGATO (SERIE LG)
27
