Wall Mounting
1. Insert batteries
into Keypad following polarity markings.
2. Fasten to wall
by screwing the screws through the two holes into the wall. Screws should be
fastened to a stud, a single gang box, or with wall anchors into drywall. Ensure power supply
wires are routed through wire window and seated in wire channel if wire does not run behind
drywall.
3. Route power cable
using one of two methods.
A. Wires to Terminal Block: Connect one end of the wires to the terminal block. Splice the
other end of the wires to the provided power supply. Polarity does not matter. Wire
lengths must not exceed lengths listed below.
B. Barrel Plug: Connect the power supply by inserting the barrel plug into the black port.
Orient the connector as shown.
4. Insert the Keypad
into the wall mount. Push any extra wire through wire window before
inserting onto wall mount. Slide the Keypad until it "clicks" into place.
5. Plug in power supply.
WIRE
GAUGE
MAXIMUM LENGTH BETWEEN
POWER SUPPLY AND KEYPAD
#24
Up to 50 feet
#22
Up to 100 feet
#20
Up to 150 feet
#18
Up to 250 feet
#16
Up to 400 feet
Wire window
Wire channel
Terminal block
Screw hole
Screw hole
Barrel plug
