CLARKE TECHNOLOGY Operator's Manual - Vision 17B/BT
Page -17-
MAINTENANCE (cont'd)
3. Leave the tanks and the drain hoses open to dry
in the air.
4. Check and clean the squeegee blade. Use a soft
cloth to clean the squeegee blade. If the squee-
gee blade is damaged or worn, turn or replace
the blade.
5. Check and clean the vacuum gaskets, the vac
screen filter and the solution screen filter. Re-
move and clean with a vinegar-water solution or
warm soapy water. Rinse the parts in clean
water.
WARNING:
Lead acid batteries generate
gases which can cause an
explosion. NO SMOKING.
Always wear eye protection
and protective clothing when
working near batteries.
6. Check the batteries and add distilled water as
needed. The plates must be covered before
charging. After charging, check to be sure that
the correct level is to within 1/4 of the bottom of
the tube in each cell.
7. Charge the batteries. See the instructions in the
section of this book called "How to Charge the
Batteries".
8. Use a clean cloth and wipe the surface of the
machine.
9. Remove the brush or pad driver. Rinse clean
and allow to dry. Discard the pad if necessary.
10. Store the machine and accessories in a dry
building.
NOTE: Grease axle assembly wheels once a week.
Figure 28
