Page -12-
CLARKE TECHNOLOGY Operator's Manual -Vision 17B/BT
HOW TO PREPARE THE MACHINE FOR OPERATION (cont'd)
8. To remove a brush or pad driver, turn the pad
driver or brush to the left and remove.
9. Lift up the machine with the lift handle and
return the support leg to its normal position.
CAUTION:
Leaving the brush motor
switch in its "DOWN" position
when the machine is not in
use can damage the brush or
pad driver. Always leave the
brush motor in the "UP"
position while not in use.
How to Install the Batteries
To install the batteries, follow this procedure:
NOTE: Batteries must be fully charged before
operating. See section in this manual, "Charging
the Batteries".
WARNING:
Lifting batteries without help
could result in an injury. Get
help to lift the batteries. The
batteries are heavy.
WARNING:
Working with batteries can be
dangerous. Always wear eye
protection and protective
clothing when working near
batteries. NO SMOKING.
1. Empty both the recovery and solution tanks.
(See - "End of Work Procedures").
2. Unlock the hold-down clamps located at the rear
on either side of the machine. See figure 19.
3. Raise the battery compartment of the machine
"up" by lifting up on the handle at the rear of
the machine.
4. Install the batteries using the battery lift handles.
See figure 20 for proper positioning of the
batteries.
5. Close the battery compartment and re-lock the
hold-down clamps.
6. Join the connector from the batteries to the
connector attached to the tank support.
Figure 19
Figure 20
