Alpinespas SPA POOL, Manual

Page: 68 / 96

68
7. GETTING TO KNOW YOUR SPA POOL
GLACIER SPA POOL OVERVIEW
Components:
Spa Pool Controller SpaNet SV3-VH
Topside Control Panel SpaNet SV3-VH
Heater Element 6KW (Variable)
Pumps 1x Circulation Pump + 3x Jet Massage Pump (3HP) + Air Blower
Skimmer/Filter Type 2x Floating Weir Filter
Sanitizers Ozone, Ultra-Violet
Electrical Info 32amps - 45amps. 230 - 240V AC 50hz IPX5
Cable No Cable - Hardwiring Required.
Hardwire Required:
This spa pool requires direct hardwiring from the circuit board to the system
controller with suitable electrical cable.
Locating the Controller
Remove the cabinet panels from the side of the spa that houses the controller (see
following picture for exact location).
BELOW DIAGRAMS ARE FOR 32A - 45A CONNECTIONS.
DIP SWITCHES ARE PRESET FOR SINGLE PHASE.
P3
P2
CS
P1
G
N
ON
S1 S6 S1 S6
P3
P2
CS
P1
G
N
ON
DO NOT POWER THE SPA BEFORE IT HAS BEEN FILLED
SINGLE PHASE THREE PHASE
DIP SWITCHES DIP SWITCHES
A 32amp connection will require load shed/limiting for the components as they
cannot all run simultaneously. See the SpaNet user guide for more information.
A 45amp connection provides power for all components to run.