Alpinespas SPA POOL, Manual

Page: 29 / 96

29
Filter Cycles
A filter cycle is a period in which the circulation pump is run for a user programmed
length of time. This allows for a dedicated period of water sanitizing and clean up.
At the start of each filter cycle, the blower (if there is one) and main jet pump may
run briefly to purge the plumbing to maintain good water quality.
Filter cycle operation consists of two separate programmable parameters:
- Duration of filtration per day [FILT] (hours per day, e.g. 4 hours total per day)
- Filter cycle blocks [F.CYC] (time between start of each filter cycle, e.g. 4 hours)
The default settings are: 4 hours filtration per day with 4 hour filter blocks (Every 4
hours, an hour long filter cycle will engage.)
Setting Filter Cycle Hours of Filtration [FILT]
Setting Filter Cycle Blocks [F.CYC]:
Sleep Timers [SNZE]
Sleep timers are a very handy feature which enables the user to stop all spa pool
activity during certain times of day or night. While the controller is sleeping NO
automatic heating or filtration maintenance will occur, however the spa pool can
still be operated by manual use without the need to adjust sleep time settings.
There are two individual sleep timers that can be set, each of which can operate on
one or more specified weekdays. This enables the user to program different sleep
times for different days (i.e. weekdays vs weekends), as well as customizing the
settings on a particular day/time where the user may want the spa pool silenced.
Default Setting = Sleep Timer 1 (Sat – Fri; Sleep period 22:00 – 07:00).
A full SpaNet control panel guide including sleep timer settings can be
downloaded from our support page: http://alpinespas.co.nz/support/
Press and hold the
‘UP/DOWN’ buttons
together. The word
[MODE] will display.
Press and hold the
‘UP/DOWN’ buttons
together. The word
[MODE] will display.
Enter FILT by
pressing the ‘OK’
button.
Enter F.CYC by
pressing the ‘OK’
button.
Scroll to FILT by
using the ‘UP/
DOWN’ buttons.
Scroll to F.CYC
by using the ‘UP/
DOWN’ buttons.
Select duration
between 1-24hrs
with ‘UP/DOWN’
buttons.
Confirm duration
selection with the
‘OK’ button.
Confirm duration
selection with the
‘OK’ button.
Let screen timeout
(10 secs) back to the
default display.
Let screen timeout
(10 secs) back to the
default display.
Select duration
between 1-24hrs
with ‘UP/DOWN’
buttons,