Next, place the two floor panels inside and fix with 2x
‘4*40mm’ screws per panel using the pre-drilled holes.
Add back rests for the bench seats where you wish.
Count to the 16th stave up from the bottom stave
(bottom stave not counted) on each side of the sauna
and pencil a mark for the ‘triangular roof beam’ to be
secured. Fasten each beam with 5x ‘3*30mm’ screws
across the length of the sauna on each side. The
triangular beam is should sit level with the top edge of
the 16th stave.
Place the vents into the pre-drilled holes around the
sauna. Note the size of the vents - the floor stave vent
will be slightly smaller.
Bend out the small nodes of each vent using a flat head
screw driver (or something similar).
50.
51.
49.
48.
4.
INSTALLATION INSTRUCTIONS
23
16
15
14
13
12
11
10
9
8
7