Lay out the ‘Back Panel Parts 1, 2 & 3’ flat on ground
with the pre-installed bench supports right side up.
The vent hole identifies the bottom of the back panel.
Measure the depth of the groove in the 13 staves you
have secured.
Secure the back panels together using 4x ‘5*70mm
Screws’ into the pre-drilled holes labeled below at the
top and bottom of the panel.
This measurement will be used to mark the indentation
distance between each of the four ‘panel set securing
pieces’ and the edge of the front at back panels.
12.
14.
13.
15.
14
Outdoor Bench Supports
Vent Hole
Heater Power Cable Hole
Pre-installed
1
2
4
3