There are four double ended screws for the end cradle
supports. Screw part A, with the broad screw thread,
into the end cradle so the bolt end (part B) is left
sticking out.
Secure the cradle support lengths by placing the half
moon steel washer, standard washer and nut on to each
thread appearing in the pre-created hole on the side.
Tighten the nut using a socket set.
Make sure each support is tightly fixed to the cradle.
use a tool with a 90 degree edge to make sure each
support sits square to the cradle.
5.
6.
7.
12
B
A