19
BLADE INSPECTION, INSTALLATION, AND REMOVAL
DANGER!
Be sure to unplug the power cord from the outlet before attaching or removing the
saw blade from the tool. Accidental starting of the motor may cause bodily injury.
WARNING!
Be sure to securely tighten the fl ange assembly and all loose screws before testing the unit.
Please allow the saw blade to do the work. Applying excessive force may damage the saw
blade and cause premature failure of the bearings and gears. Such action may decrease
the rotation speed of the motor which reduces the effi ciency of the dust suction because
its power is driven by the spindle
Only use saw blades with 20mm arbors and maximum speed rating equal to or higher than
the name plate of RPM of tool.
To remove the fl ange bolt from the spindle hold Flange II in position with the 22 mm
spanner wrench (133097) while turning the fl ange bold with the T-handle wrench
(133098) in a clockwise rotation until it is removed.
With the fl ange bolt removed, remove Flange II off of Flange I.
Install your 20mm arbor saw blade onto Flange I with the arrow on the blade pointing
in the same direction as the arrow on the cover (blade will turn in a clockwise rotation),
the cutting wheel should fi t tightly on the Flange I.
Reinstall Flange II and then the fl ange bolt, turning counter-clockwise to install, once
fl ange bolt is hand tight use the 22mm spanner wrench to hold Flange II in place and
fi nish tightening the fl ange bolt with the T-handle wrench.
1.
2.
3.
4.
