13
INSTALLATION OF WATER ATTACHMENT
1.
Remove the wing screw and washer for
adjusting the cutting depth.
(See Figure-6)
2. Raise cutting depth so there is room
between the body and the base plate.
(See Figure-6)
3. Insert the plastic nozzle on the water-feed assembly behind the height adjustment
slide. Make sure that the water valve bracket (Part No. 133094) is in front of the slide.
If your blade is already installed, the plastic nozzles should be positioned so that each
nozzle directs water spray onto each side of the blade.
(See Figure-7 & Figure-8)
4. Align the water valve bracket with
the wing nut hole and insert wing
bolt.
(See Figure-9)
5. Adjust the height of the blade and securely tighten the wing bolt.
Figure-7
Figure-8
Figure-6
Figure-9
