8
ADDITIONAL PRECAUTIONS FOR USING
THE WET STONE CUTTER
In addition to the general safety notes described on the preceding pages, please read
and observe the following precautionary notes before using the wet stone cutter.
DANGER!
INSTRUCTIONS
Alpha Professional Tools
®
provides the highest quality parts and manufacturing techniques
in the manufacture of this tool. In order to obtain the maximum effectiveness and provide
the highest degree of safety, it is necessary to review and follow these instructions carefully
before using the tool.
SAFETY ADVICE
•
Please note safety instructions on Page 3-5.
•
Do not pierce the motor housing as this could damage the double insulation.
•
Always remove plug from the outlet before making any changes to the settings or
carrying out maintenance.
•
Only plug-in when machine is switched off.
•
Keep power cable clear from working range of the machine. The power cable should
always lead away from you and behind the operating area.
•
Before use, check the machine, cable and plug for any damages or material fatigue,
only authorized service agents should carry out repairs.
•
After switching off, the machine will not idle down immediately. Allow the machine to
come to a complete stop before putting it down.
•
Always wear safety glasses and ear protection when working with this machine. It
is further recommended to wear safety gloves, apron, as well as sturdy non-slipping
shoes.
•
Only use saw blades whose permitted speed is at least as high as the highest no-load
speed of the machine.
•
Be sure saw blade fi ts tool properly and securely. Do not modify the tool to force fi t the
blade. For example do not remove blade guard.
•
Check cutting tools before use. The saw blade must be properly mounted and turn
freely. Perform a test run for at least 30 seconds without any load. Do not use damaged,
out of round or vibrating cutting tools.
•
Immediately switch off the machine in case of considerable vibrations or if other
malfunctions occur. Check the machine in order to fi nd out the cause.