22
Ba ery Charging
Posi on all charger cords and wires in loca ons that will not be driven over or present a tripping hazard.
Your Ba ery Charger is fully automa c and will supply su
ffi
cient power to bring your Alpha EV ba eries to a full
charge. It will also shut itself o
ff
when the ba eries are fully charged. If le connected to the ba eries and with
AC Power, the charger will occasionally check the ba eries condi on and apply enough power to maintain a full
charge. It is recommended to plug the charger in even a er short trips (10 Minutes). This will assist in ge ng the
maximum life from your Alpha EV ba eries.
For proper charging of your Alpha EV Wet
‐
Flooded & AGM Ba eries, follow the instruc ons below:
I. Put
your
3
‐
Posi on Direc onal Switch in Neutral.
II. Turn
your
2
‐
Posi on Key Switch to the O
ff
Posi on.
III. Insert you’re the DC side of your Charger Power Cord (Supplied with your Alpha EV) into the matching DC
Receptacle (located on the outside of the body near the driver’s side).
IV. Insert the AC Side of your Charger Power Cord to an AC Outlet.
V. During normal charging, the charging light blinks or con nually illuminates as follows.
POWER
ON
LIGHT
= Red / Blinking *** Low Ba ery Power.
POWER
ON
LIGHT
= Red / Blinking * Ba ery Charge Lower Than 80%.
POWER
ON
LIGHT
= Yellow / Blinking * Ba ery Charge Between 90%
‐
100%.
CHARGE
COMPLETE
LIGHT
= Con nuous Green.
Do not disconnect the DC Output Cord from the ba ery charging receptacle when the charger is on and charging
the ba eries.
A er the Charge is complete, disconnect the DC Outlet Plug. Grab the plug body
fi
rmly and pull straight out of the
receptacle.
Contact your Alpha EV Dealer should you have an addi onal Charging Issues as your charger contains an
addi onal (11) Fault Codes to assist with your System Diagnosis.
Summary of Contents for ALPHA EV 2+2
Page 2: ...2 NOTES...
Page 30: ...30 NOTES...
