10
Subject to technical amendments without notice | 83050700gUK – Translation of the original operating manual | ait-deutschland GmbH
18.2 Transport to installation location
Always comply with the following safety information
during transport:
WARNING!
Several people are required to transport
the unit. Take into account the weight of
the unit.
“Technical data / Scope of delivery” overview,
“General unit data” section,
CAUTION!
Wear safety gloves.
WARNING!
The unit can tilt and tip over when being
removed from the wooden pallet and dur‑
ing transport. This can result in personal
injury and damage to the unit.
– Take suitable precautions to prevent the
risk of tipping over.
IMPORTANT
Never use components and hydraulic con-
nections on the unit for transport purposes.
IMPORTANT
Do not tilt the unit more than a maximum of
45° (in any direction).
To prevent transport damage, you should transport the
unit to its final place of installation in its packed con
-
dition (on the wooden pallet with packaging) using a
pallet truck.
If it is not possible to transport the unit to the final
installation location using a pallet truck, you can also
transport the heat pump on a handcart.
Before transporting with a handcart, we recommend
removing the front panel in order to reduce the weight
of the unit.
Remove packaging and set extra box aside (will
be needed later on!).
Remove angle bracket, transport and packaging
material from the unit.
Dispose of angle bracket, transport and packag-
ing material properly and in an ecologically com-
patible way.
Lift unit from the pallet.
Remove front panel of unit.
•
To do so, loosen the quick-release screws. Turn
through 90° to the left.
•
Lift front panel and set aside in a safe place.
Push handcart under the rear side of the unit.
IMPORTANT
If the handcart is pushed under the unit at the
rear panel, ensure you do not damage any
connections during transport.
IMPORTANT
Transport with a handcart on the front side of
the unit is not permitted.
IMPORTANT
Do not tilt the unit more than a maximum of
45° (in any direction).
18.3 Installation
CAUTION!
Several people are required to install the
unit.
NOTE
Always refer to and follow the installation plan
for the respective model. Note the minimum
clearances.
Installation plan for the respective model
If you have no already done so, remove angle
bracket, transport and packaging material from
the unit. Set the extra box to the side and lift the
unit from the wooden pallet.
“Transport to installation location”
Dispose of angle bracket, transport and packag-
ing material properly and in an ecologically com-
patible way.
