11
Subject to technical amendments without notice | 83050700gUK – Translation of the original operating manual | ait-deutschland GmbH
Set unit on a stable, solid and level, preferably
sound-insulated surface. Ensure that the floor is
designed for the weight of the heat pump.
Set up the unit so that the switchbox side (= oper-
ator side) is accessible at all times.
“Technical data/Scope of delivery” overview,
“General unit data” section
Use the Sylomer strips supplied to level out any
minor unevenness.
The Sylomer strips give the heat pump additional
stability. They absorb sound and vibrations trans-
fer to the floor.
Place the Sylomer strips under the heat pump as
follows:
•
Tilt the unit to one side, slowly and carefully.
Secure unit in raised tilted position so that it can-
not accidentally tip back into the original position.
IMPORTANT
Do not tilt the unit more than a maximum of
45° (in any direction).
CAUTION!
Hands and fingers could be crushed dur‑
ing the following work!
•
Position a Sylomer strip under the unit, flush with
the respective outer edge.
•
Slowly and carefully tilt the unit back into its initial
position.
Repeat steps • to • for the remaining sides
of the unit.
Position Sylomer strips at right angles to each
other, end-to-end:
Front side of unit (= operator side)
