S.G. Elettronica S.r.l
- Via E. Ferrari , 28 - 30037 Scorzè (VE) Italy - Tel +39 041 5841973 Fax +39 041 5841979 - www.almot.it - [email protected]
3
DIP 4
FUNCTION
OFF
Settings of the working times
STANDARD
.
ON
Settings of the
TEST
timings of work (the wor-
king times are reduced to
10—12
seconds).
2.3 FUNCTIONS DIP SWITCH 870N
3.0 GENERAL RULES OF FUNCTIONING
During the wiring
strictly respect the diagram of connection
, a wrong connection
could damage the
installation
. Follow the diagram more appropriate to the installation. (
paragraph 2.1
)
Do not use
, for the command,
stable position switches
.
Do not exceed 50 mt
of cable between the control unit and the anemometer.
After supplying the control unit (in case of installation on an awning) position
the awning on half of
the run
, rotate the sensor and check that
after the alarm happened
(flashing red led), the awning goes up
(closing). In case that it goes backwards, invert the wires on the MOTOR OPENS clamp, to the MOTOR
CLOSES clamp.
Position the sensor in an optimal position for receiving the wind, as close to the awning as possible.
If during the installation, with the
continuous opening and closing
of the awning, shutter or vasistas,
the motor gets stuck
, this is
not because of a damage
of the board, but because of the
thermic protector
contained in the motor.
Wait until the motor has cooled down and try again
.
4. 0 PROGRAMMING FIRST TX MASTER BY REMOTE (IF THERE IS NO TX STORED)
4.1 PROGRAMMING OF OTHER TX BY MASTER TRANSMITTER
DIP 5
FUNCTION
OFF
Functioning of the command switches
IMPUL-
SIVE.
ON
Functioning command switches
t
o DEAD
MAN.
1) Supply the control unit 2) The motor will do
two short opposite
movements which indi-
cate that
there are no
TX stored in the control
unit’s memory
3)
Within a few seconds
press the
STOP
switch of
the TX to memorize.
4) The motor will do two
short movements which
indicate that the TX has
been memorized.
Release
the STOP of the
TX.
5) Programming accompli-
shed.
1) When the control unit
has been supplied, press
and hold the hidden
switch of the
TX master
already
stored.
2) The motor will do
two short movements
which indicate
the
storing has begun.
4)
Within a few se-
conds
press the
STOP
switch of the TX to
memorize.
5) The motor will do
two short move-
ments which indicate
that the TX has been
memorized.
6) Programming
accomplished.
3) Release the hidden
switch of the TX.
