S.G. Elettronica S.r.l
- Via E. Ferrari , 28 - 30037 Scorzè (VE) Italy - Tel +39 041 5841973 Fax +39 041 5841979 - www.almot.it - [email protected]
WARNING READ CAREFULLY THE FOLLOWING SAFETY INDICATIONS BEFORE TO START THE INSTALLA-
TION OF THIS DEVICE; THEY ARE USEFUL TO PREVENT ANY ELECTRICAL CONTACT, INJURY AND OTHER
PROBLEMS. KEEP THIS MANUAL FOR OTHER CONSULTATIONS.
The control units are intended exclusively to the control of the weather for the automatic movement of
the awnings, shutters, vasistas and lights.
The use for applications which are different from the ones indi-
cated must be authorized by the manufacturer, after the technical test of the application.
The installation of the device must be made by technical and qualified staff.
After having removed the packaging, check that the device is intact.
Plastic bags, styrofoam, small metallic components as nails, clips, etc. have to be kept out of reach of
children, because they might be dangerous.
Before to connect the device, verify that the electrical supply that you use, has the same features
indicated in the label with the technical infos, applied on the device.
This device has been intended just and exclusively for the use for which it has been programmed
and the manufacturer can not be held accountable for the damages caused by its improper use.
The installation of the device has to be made according to the instructions of the manufacturer. Non
-compliance with these rules can compromise the safety.
The implementation of the electrical installation of voltage supply has to be made according to the
current rules.
To avoid any danger of injuries or death caused by the voltage supply, before implementing any ope-
ration of wiring or regulation, turn off the voltage from the supply line.
To assure an effective separation from the net we suggest to install a momentary bipolar switch
(button) approved. At the beginning of the command line a general omnipolar switch of supply with
input of the contact of at least 3mm, must be installed.
Do not clean or wash the device with solvent or jets of water. Do not immerse into water.
Warning
: in case of damage or malfunction, turn off the device from the general switch and call a
qualified technician.
Every repair have to be implemented only by qualified staff in an help centre authorized by the ma-
nufacturer.
Before implementing any operation of cleaning or maintenance, be sure to disconnect the device
from the net. For further safety we suggest to remove the electrical connection.
Request always and exclusively the use of original replacements. The non-compliance with this rule
could compromise the safety and undo the benefits of the warranty applied on the device.
In case of problems or doubts during the intallation of the functioning, address to your retailer of
trust or directly to the manufacturer.
1. SAFETY INTICATIONS
