PAGE
30
ALMAC s.r.l.
2.8
Safety indications on the use of the travel function
The instructions given below must be followed.
•
Make sure movements are done on flat, sturdy ground. To do this, use the
spirit level located on the work platform.
•
Make sure that there are no hollows or ridges in the floor and that there is
enough room for the machine to pass through.
•
Make sure that there are no bystanders or obstructions in the surrounding
area before moving off
•
Do not CHANGE DIRECTION on kerbs, rocks or appreciable differences in level
(> 10 cm) when driving the machine. In this case, always proceed
perpendicularly to the obstacles.
•
If you must drive up a slope, do not change direction when the ground
changes from flat to sloping. If this is absolutely necessary, perform the
manoeuvre gradually.
•
Do not drive along the edge of slopes or over uneven ground with one track
horizontal and the other slanting or partially raised (>10°) as this will damage
Summary of Contents for Athena 870-BL EVO
