19
Data Transfer (for Model FMT-110WT only)
Model FMT-100WT instruments can transfer measuring data by means of a RS-232C interface. A 9-p D-Sub
connector is provided for this purpose, which can be found at the side of the instrument. A connector cable for
the serial I/O port is also included in the scope of delivery.
RS-232C Interface
The RS-232C interface can be used for the direct communication between an appropriate serial I/O-card of a
computer and the instrument. The minimum requirement for the data transfer up to 19200 baud is the
connection of the RXD, TXD and GND communication terminal.
Specification
Baud rate
2400, 4800; 9600 or 19200 (selectable, see general settings)
Data length
8 bits
Stop bit
1
Parity None
Protocol Code
Extern >> FMT AAcr Tare
ABcr
Stop
Output
ACcr
Change to Peak Mode
ADcr
Change to Average Mode
AEcr
Reset
Peak
AFcr
Change Units to kg (g)
AGcr
Change Units to N
AHcr
Change Units to lb (oz)
BAcr
Data output request (single reading)
BBcr
Data output request (10/sec)
BB1cr
Data output request (20/sec)
BB2cr
Data output request (50/sec)
BB3cr
Data output request (100/sec)
BDcr
Units confirmation request
BEcr
Peak data output request
BFcr
Minus peak data output request
cr
(carriage
return)
FMT >> Extern Average data output
3. digit:
+ /or -
4.-6. digit. Value incl. floating decimal point
NA
cr
Summary of Contents for FMT-100WT
Page 2: ...2 ...
Page 3: ...3 Deutsch 4 English 14 Francais 24 Espanol 34 Italiano 44 ...
Page 55: ...55 ...
Page 56: ...56 ...