USAGE OF CLEANING DETERGENTS
TO APPLY DETERGENT:
1. Select a detergent/cleanser appropriate for the intended
application.
2. Prepare detergent solution as recommended by the
manufacturer.
3. Remove cap over the detergent bottle located on the side
of the Pressure Washer.
4. Fill bottle with prepared detergent solution. A small
funnel may help with this task. Replace the detergent
bottle cap.
5. Set (turn) the Pressure Adjust Collar to low pressure
position.
Detergent will
NOT
flow until the Pressure Adjust Collar is set
(turned) to low pressure position.
6. Pull spray gun trigger and apply detergent to a dry surface, starting at lower portion of
area to be washed and work upward, using long, even, overlapping strokes.
Wetting the surface first is not recommended, as it dilutes the
detergent and reduces its cleaning ability.
7. Allow detergent to “soak in” for 3-5 minutes before washing and rinsing. Reapply
as needed to prevent surface from drying. Do
Not
allow detergent to dry on surface
(prevents streaking).
TO RINSE:
1. Reset the Pressure Adjust Collar to high pressure, press the trigger and wait for the deter-
gent to clear.
2. Keep the spray gun a safe distance from the area you plan to spray.
3. Apply a high pressure spray to a small area, and then check the surface for damage. If no
damage is found, it is okay to continue cleaning.
4. Start at the top of the area to be rinsed, working down with same overlapping strokes as
you used for washing and applying detergent.
When you have completed use of the detergent injection system, continue to run in low pres-
sure mode and flush clean water through the detergent bottle until it is thoroughly cleaned.
Failure to clean properly will cause the injection system to become
clogged and inoperable.
16