2.
With its
larger internal bore (hose
end) facing up, clamp the Valve Nut
(12) in a vise, as shown in Figure 11-19.
NOTE
The threads on the hose side of the
Valve Nut are left hand threads.
Turn the hose:
·
Clockwise to loosen.
·
Counterclockwise to tighten.
3.
Thread one of the Whip Hose (13) ends
into the Valve Nut, turning the hose
counterclockwise until it bottoms in
the Valve Nut.
4.
Back the Whip Hose out of the Valve
Nut ½ of a turn clockwise.
This allows linear expansion of the
hose when it is compressed by the ta-
pered end of the Valve Stem during
procedure11.7, below.
NOTE
DO NOT put strain on the Valve Nut to
Whip Hose connection before the Valve
Stem is installed. The Valve Nut can be
pulled from the Whip Hose until the ta-
pered end of the Valve Stem locks the
A
LLIED
4000C Series Hole-Hog
55
Body/Anvil
End Cap
Striker
Insert Valve into Striker
Figure 11-27. Insert Valve into Striker.
Internal Threads of
the Body/Anvil
External Threads of
the End Cap
Apply Anti-Seize Lubricant to:
Lubricate Valve Components
Figure 11-26. Prepare Tail Assembly and Body
Anvil for Assembly.
Figure 11-25. Install Striker into Body/Anvil.
Block Body/Anvil side to side to
prevent rolling during assembly.
Block end of Body/Anvil for clear
access to threaded opening.
Figure 11-24. Blocking the Body/Anvil