26
2. Use a screw driver or needlenose plyers
to pry the Gasket (16) from the Socket.
Discard the gasket. Refer to Figure 8-12.
3. Separate the Q.D. Plug (15) from the
Whip Hose (13) by threading the Q.D.
Plug (15) out of Hose Socket (14). Refer
to Figure 8-13.
a. Use a 2-inch open-end wrench to hold
the Hose Socket (14).
b. Use a 2-inch open-end wrench to
thread the Q.D. Plug (15) from the
Hose Socket (14).
c. To remove the hose socket from the
Whip Hose (13), refer to step 6, below.
4. Separate the Q.D. Socket (17) from its
Hose by threading the Q.D. Socket (17)
out of the Hose Socket (14). Refer to Fig-
ure 8-14.
a. Use a 2-inch open-end wrench to hold
the Hose Socket (14).
b. Use a 2-inch open-end wrench to
thread the Q.D. Socket (17) from the
Hose Socket (14).
c. To remove the hose socket from its
hose, refer to step 6, below.
5. Refer to Figure 8-15. Inspect the Roll
Pin (11) for damage and correct height.
The Roll Pin should extend 1/4-inch
from the Valve Nut (12).
·
If either the Roll Pin (11) or Valve
Nut (12) must be replaced, replace
both components.
A
LLIED
4000 Series Hole-Hog
Whip Hose
Hose Socket
Q.D. Plug
Figure 8-13. Whip Hose, Socket and
Q.D. Plug.
Valve Nut
Roll Pin
0.25 inch
Whip Hose
Figure 8-15. Valve Nut Assembly
Hose Socket
Supply Hose
Q.D. Socket
Figure 8-14. Q.D. Socket and Hose
Q.D. Gasket
Q.D. Socket
Figure 8-12. Remove Q.D. Gasket