Plug (15) out of Hose Socket (14). Refer
to Figure 11-8.
a. Use a 2-inch open-end wrench to hold
the Hose Socket (14).
b. Use a 1-1/2-inch open-end wrench to
thread the Q.D. Plug (15) from the
Hose Socket (14).
c. To remove the hose socket from the
Whip Hose (13), refer to step 6, below.
4.
Separate the Q.D. Socket (17) from its
Hose by threading the Q.D. Socket (17)
out of the Hose Socket (14). Refer to
Figure 11-9.
a.
Use a 2-inch open end wrench to hold
the Hose Socket (14).
b. Use a 2-inch open end wrench to
thread the Q.D. Socket (17) from the
Hose Socket (14).
c. To remove the hose socket from its
hose, refer to step 6, below.
5.
Refer to Figure 11-10. Inspect the Roll
Pin (11) for damage and correct height.
The Roll Pin should extend 1/4-inch
from the Valve Nut (12).
·
If either the Roll Pin (11) or Valve
Nut (12) must be replaced, replace
both components.
A
LLIED
4000C Series Hole-Hog
49
Whip Hose
Valve Nut
Hose Socket
Supply Hose (Ref.)
Valve Stem (Ref.)
Q.D. Plug
Q.D. Gasket
Q.D. Socket
Quick Disconnect (Q.D.) Coupling
Figure 11-12. Whip Hose Components and Quick Disconnect Fittings.
Figure 11-11. Valve Nut and Whip Hose in Vise
Valve Nut
Roll Pin
0.25 inch
Whip Hose
Figure 11-10. Valve Nut Assembly