Allied Telesis AT-GS950/16PS, User Manual

Page: 269 / 386

AT-GS950/16PS Switch Web Interface User’s Guide
269
Port Access
Control
Configuration
To configure port-based access control, perform the following procedure:
1. Select the Security folder from the main menu on the left side of the
page.
The
Security folder expands.
2. From the Security folder, select Port Access Control . The Port
Access Control Configuration Page is displayed. See Figure 107.
Figure 107. Port Access Control Configuration Page
3. Configure the following parameters as required:
NAS ID - This parameter assigns an 802.1x identifier to the switch
that applies to all ports. The NAS ID can be up to sixteen
characters. Valid characters are 0 to 9, a to z, and A to Z. Spaces
are allowed. Specifying an NAS ID is optional.
Port Access Control - This parameter enables or disables Port
Access Control. Select one of the following choices from the pull-
down menu:
Enable: The Port Access Control feature is activated.
Disable: The Port Access Control feature is de-activated.
Authentication Method - This parameter indicates the
authentication method used by the switch. Select one of the
following choices:
RADIUS: This parameter configures port security for remote
authentication. After completing steps 4 - 6, you must configure
the “RADIUS Client” on page 273.
Local: This parameter configures port security for local
authentication. After completing steps 4 - 6, you must configure
the parameters for “Dial-in User— Local Authentication” on
page 276.
4. Click Apply when you are finished configuring the parameters.