Allied Telesis AT-GS950/16PS, User Manual

Page: 112 / 386

Chapter 7: LACP Port Trunks
112
Port Priority Configuration
To select a priority for an LACP port, perform the following procedure:
1. Select the Bridge folder.
The Bridge folder expands.
2. From the Bridge folder , select the Trunk Config folder.
The Trunk Config folder expands.
3. From the Trunk Config folder, select Port Priority .
The AT-GS950/16PS Port Priority Page is displayed. See Figure 35
for a partial view of this page.
Figure 35. AT-GS950/16PS Port Priority Page
The System Priority is a preassigned value that you cannot alter. This
value applies to the switch. See “System Priority” on page 105.
The System ID is a MAC address value assigned to the switch. You
cannot change this value.
4. To set the port priority, select a value from 0 to 255 in the Priority
column for the port you want to alter. For more information, see “Port
Priority Value” on page 106
5. Select Apply .
6. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.