8
Patch Release Note
Patch 86251-05 for Software Release 2.5.1
C613-10356-00 REV F
The ENTRY parameter from the ADD IP FILTER command was not
included in the output of the SHOW CONFIG DYNAMIC command. This
issue has been resolved.
An enhancement allows for the creation of static IGMP group memberships
that do not time out. For details on this feature, see “
Static IGMP
” on
page 24.
DHCP was offering network and broadcast addresses to clients. This issue
has been resolved.
An error was not returned if the SET FIREWALL POLICY RULE command
was executed with PROTOCOL=1 when ICMP forwarding was turned on.
This issue has been resolved so that an error is now displayed.
In some circumstances the checksum for the TCP header was set to zero.
This issue has been resolved.
The Switch MIB did not show the correct
dot1StpPriority
value. This issue
has been resolved.
After creating a trunk group, the activity LEDs did not flash unless the
configuration was used at reboot. This issue has been resolved so that the
LEDs flash correctly whenever a trunk group is created.
The source IP address in a PIM
Register
message was not the DR interface’s
IP address. This issue has been resolved.
A forwarded PIM-DM state
Refresh
message did not update the metric and
preference values. This issue has been resolved.
IGMP
Query
messages were not sent after IGMP was disabled and then re-
enabled. This issue has been resolved.
PCR: 03502
Module: IPG
Level: 3
PCR: 03513
Module: IPG
Level: 3
PCR: 03515
Module: DHCP
Level: 3
PCR: 03517
Module: FIREWALL
Level: 3
PCR: 03523
Module: FIREWALL
Level: 2
PCR: 03526
Module: SWI
Level: 3
PCR: 03531
Module: SWI
Level: 3
PCR: 03468
Module: PIM
Level: 3
PCR: 03533
Module: PIM
Level: 3
PCR: 03535
Module: IPG
Level: 2
