Patch 86251-05 For Rapier Switches and AR800 Series Modular Switching Routers
5
Patch 86251-05 for Software Release 2.5.1
C613-10356-00 REV F
BGP traps were sent incorrectly when a BGP peer became Established, or
moved into a lower state. This issue has been resolved.
STP settings were not retained when a port was deleted from the VLAN that
the STP belongs to. This issue has been resolved.
When the device was acting as a DHCP client and the DHCP server
provided a gateway address, a statically configured default route was
deleted and replaced with a default route with the provided gateway
address. The correct behaviour is to only delete a dynamic default route in
this situation. This issue has been resolved; the correct behaviour is now
applied.
The IPX traffic filter match counter was not incremented if a route was
cached. This issue has been resolved.
PPP configured on a L2TP access concentrator (LAC) should be dynamic. If
PPP was incorrectly configured to be static, the static PPP was destroyed
when the L2TP tunnel was formed so that only the first connection
succeeded. This issue has been resolved so that an L2TP tunnel is not
created if the PPP is static.
When a DHCP entry expired while other DHCP entries in the range were in
Reclaim
mode, unnecessary ARP packets were generated causing an ARP
storm. This issue has been resolved.
The CIR and CIRLIMITED parameter in the SET FRAMERELAY DLC
command now regulates the behaviour of the transmission rate. Previously,
the transmission rate did not reflect changes to the CIR setting if the new
CIR was higher than the old CIR (provided that the new CIR is within the
physical maximum of the network and the hardware), or changes to the
CIRLIMITED setting if CIRLIMITED was turned ON then OFF. This issue
has been resolved.
After unplugging a fibre uplink cable and then plugging it back in, a short
Ping timeout occurred. This issue has been resolved.
Receiving PIM
State
Refresh
messages now creates and/or maintains PIM
forwarding information.
The dropped packets counter for the firewall was not incrementing
correctly. This issue has been resolved.
PCR: 03430
Module: BGP
Level: 3
PCR: 03432
Module: STP
Level: 2
PCR: 03436
Module: IP, DHCP
Level: 2
PCR: 03439
Module: IPX
Level: 3
PCR: 03441
Module: L2TP
Level: 2
PCR: 03443
Module: DHCP
Level: 3
PCR: 03444
Module: FR
Level: 3
PCR: 03446
Module: SWI
Level: 3
PCR: 03450
Module: PIM, PIM6
Level: 2
PCR: 03453
Module: FIREWALL
Level: 3
